STG Beikirch chain drive CDs Easydrive/2

Chain drive CDs EasyDrive/2

Chain drive for opening and closing bottom-hung, top-hung and side-hung windows for surface mounting. Suitable for smoke ventilation and natural ventilation.

Features:

• Small dimensions, large forces
• Large opening angles can be realized
• Low overall height
• Stainless steel chain
• Simple installation thanks to click fastening - both on the frame and on the sash - with slim brackets and concealed fastening screws
• Connectors can be connected on both sides
• Intelligent EasyDrive electronics
• Allows synchronous operation of up to 4 drives and additional connection of up to two transom motors

Technical data:

• Rated voltage: 24 V DC ( -15 % / +25%)
• Rated current: approx.1 A at 300 N
• Cut-off: integrated, electronic load cut-off
• Compressive force: max. 300 N, compressive load capacity of the chain depends on the opening width
• Tensile force: max. 300 N
• Nominal locking force: max. 3000 N
• Lifting width: 200, 400 and 600 mm (opening width can be reduced)
• Running speed: approx. 4-10 mm/s
• Connection cable: plug connector, silicone cable, 2 x 0.75 + 4 x 0.25 mm² (not included in delivery)
• Duty cycle: ED 30 referred to 10 min, 3 min ON, 7 min OFF ; cycles 6
• Service life: > 10,000 ventilation cycles at nominal load
• Ambient temperature range: -10 °C to +60 °C
• Protection class: IP 20 according to DIN EN 60 529
• Housing: aluminum
• Color: silver
• Scope of delivery: Please order drive, brackets and connection cable separately
• Acoustic measurement: LpA < 70 dB(A)

• Minimum sash height at stroke width:

Mounting on bottom-hung window, sash mounting:

• FH min = 380 mm for CDs/200
• FH min = 380 mm for CDs/400
• FH min = 750 mm for CDs/600
• FH min =       mm for CDs/800

Tilt window mounting, frame mounting:

• FH min = 380 mm for CDs/200
• FH min = 380 mm for CDs/400
• FH min = 750 mm for CDs/600
• FH min =       mm for CDs/800

Mounting on hinged window, frame mounting:

• FB min = 582 mm for CDs/200
• FB min = 720 mm for CDs/400
• FB min = 920 mm for CDs/600
• FB min = 1120 mm for CDs/800

• Dimensions:

• CDs/200 = 510 x 26 x 38 mm,
• CDs/400 = 610 x 26 x 38 mm,
• CDs/600 = 710 x 26 x 38 mm,
• CDs/800 = 810 x 26 x 38 mm,

You discover on the construction site that the opening width of the ordered drives does not fit?
No problem!
With a simple wire bridge you can adjust the basic configuration of the drives on site.
With a wire jumper you can easily

• Change the opening width
• Add or remove synchronized drives and dead bolt motors
• Redefine the zero position (= closing position)
• Advanced functions can be set via the EasyDrive software, e.g.:
  
  
• Seal relief
• Opening width
• Intervention protection: closing speed < 5 mm/s
• Four speed ranges
• Four force ranges
• Signal contact: OPEN | CLOSE | Position
• Locking direction of dead bolt drive
• Online movement of drives OPEN | CLOSE | Position

Please ask for our technical advice Tel: 09280-98111915!

Photos, videos and diagrams: Source © STG Beikirch